qBittorrent 3.3.10 NO IPV6

[mmmmm]

qBittorrent 3.3.10 NO IPV6 (requested)

No IPV6 send at announce .
The client uses global peer id so use memory reader (mR don't support memory reader for qbittorrent then don't run both at the same time) .

[Codec]

mmmm - How to check whether my announce sends ipv6 or not?

[anon]

mmmm - How to check whether my announce sends ipv6 or not?

I think this is decided by the "Listen on IPv6" setting, but you can use a packet sniffer to be sure (see the tutorial in his signature).

[Codec]

I think this is decided by the "Listen on IPv6" setting, but you can use a packet sniffer to be sure (see the tutorial in his signature).

anon - I've been using the wrong client (the one that sends IPV6 for months) Will there be any problems when i switch to this one?

[mmmmm]

I tested it myself and make a clean installation for both qbittorrent 32/64 bit at windows 7 64bit "Listen on IPv6" setting NOT checked" , found the announce always send IPV6 , So the default client is always send IPV6 unless yours don't (you need check your announce).

[anon]

anon - I've been using the wrong client (the one that sends IPV6 for months) Will there be any problems when i switch to this one?

No (it looks like your trackers don't pay attention to this detail), but be more careful in the future.

[mmmmm]

No (it looks like your trackers don't pay attention to this detail), but be more careful in the future.

or he was using the correct client .

[Codec]

or he was using the correct client .

mmmmm - I have sent you a pm with startstop.txt download link.

[mmmmm]

I replied
yours send IPV6 .

[egy]

Hello mmmmm

May I know about my start and stop,
Because I'm not sure which one to use.

Thank you.

[mmmmm]

Hello mmmmm

May I know about my start and stop,
Because I'm not sure which one to use.

Thank you.

Yours NOT send IPV6 .