qBittorrent 3.3.10 NO IPV6 (requested)
No IPV6 send at announce .
The client uses global peer id so use memory reader (mR don't support memory reader for qbittorrent then don't run both at the same time) .
Printable View
qBittorrent 3.3.10 NO IPV6 (requested)
No IPV6 send at announce .
The client uses global peer id so use memory reader (mR don't support memory reader for qbittorrent then don't run both at the same time) .
mmmm - How to check whether my announce sends ipv6 or not?
I think this is decided by the "Listen on IPv6" setting, but you can use a packet sniffer to be sure (see the tutorial in his signature).Quote:
Originally Posted by Codec
anon - I've been using the wrong client (the one that sends IPV6 for months) :frown: Will there be any problems when i switch to this one?Quote:
Originally Posted by anon
I tested it myself and make a clean installation for both qbittorrent 32/64 bit at windows 7 64bit "Listen on IPv6" setting NOT checked" , found the announce always send IPV6 , So the default client is always send IPV6 unless yours don't (you need check your announce).
No (it looks like your trackers don't pay attention to this detail), but be more careful in the future.Quote:
Originally Posted by Codec
or he was using the correct client .Quote:
Originally Posted by anon
mmmmm - I have sent you a pm with startstop.txt download link.Quote:
Originally Posted by mmmmm
I replied
yours send IPV6 .
Hello mmmmm
May I know about my start and stop,
Because I'm not sure which one to use.
Thank you.
Yours NOT send IPV6 .Quote:
Originally Posted by egy