uTorrent 3.5.5 Build 45505

[anon]

This client sends a static and global peer_id and key, so make sure your real uTorrent does the same (Preferences -> Advanced -> set bt.randomize_peer_id to false) and to use the memory reader.

Note: do not enable "protocol enhancements"! That changes the peer_id prefix, and this emulation assumes the default one.

[alltogether]

Hi the local memory reader doesn't work with this it gives the option of utorrent(13192)(100)(9568).

[anon]

The right choice is "µTorrent 3.5.5 (build 45505) [32-bit]" and it should show up as such. If you don't see it, make sure RM+ is running as administrator and you haven't renamed the client's executable from utorrent.exe. In a worst-case scenario, using the remote memory reader locally should always work.

[alltogether]

The right choice is "µTorrent 3.5.5 (build 45505) [32-bit]" and it should show up as such. If you don't see it, make sure RM+ is running as administrator and you haven't renamed the client's executable from utorrent.exe. In a worst-case scenario, using the remote memory reader locally should always work.
Hi it doesn't, can you test it on your end please.
Thx.

[anon]

I did before replying :wwink: Both memory readers worked out of the box.

[alltogether]

Hmm then it must be my end... Honestly can't figure out what I'm doing wrong. And as I am one not to give up easily, can you give me step by step from installation to get it working as I may have miss a step.
Many thanks.

---------- Post Merged at 06:46 ---------- Previous Post was at 06:46 ----------

Hmm then it must be my end... Honestly can't figure out what I'm doing wrong. And as I am one not to give up easily, can you give me step by step from installation to get it working as I may have miss a step.
Many thanks.