PDA

View Full Version : [qBitTorrent] qBittorrent 4.2.4



anon
24.04.20, 15:45
As of version 4.0.4, this client uses an individual peer_id, so it's okay to run both mRatio and qBittorrent at the same time. Also, this emulation now has support for the "IP/hostname to report to tracker" feature, should you ever need that.

This client emulates the following settings, so make sure your real qBittorrent 4.2.4 also uses them:

Encryption mode: Allow encryption
Optional IP address to bind to: All addresses (but read the comments regarding IPv6 below)

...the "Listen on IPv6 address" checkbox, it has been removed in 4.2.1 (which I unbelievably also failed to notice), with "Optional IP address to bind to" now apparently being the favored way to accomplish that, and set to "All addresses" by default.

I always cross-check client files against the real thing before posting them, and this one obviously passed that test, but I have no IPv6 connectivity whatsoever. It is possible that for those with a dual-stack setup, an IPv6 address may now be explicitly reported to the tracker (which this emulation doesn't do) under the default settings. Feedback on this matter would be appreciated.

Very important: after changing the emulation for your torrents, be sure to close mR and open it again.